YOUR CUP HOLDER WASN'T BUILT FOR THIS CENTURY.
CupDock turns one cup holder into a phone command deck — engineered to hold your line, your GPS, and your drink. All at once. No trade-offs.
- No tools. No drilling.
- Docked in under 10 seconds
- Fits standard console cup holders
PICK ONE: YOUR NAVIGATION. YOUR DRINK. — ACTUALLY, DON'T.
Every phone mount on the market steals your cup holder to give you a screen. CupDock doesn't ask you to trade. It stacks — cradle above, cup below, cable out of sight — so the one slot in your console does the job of two.
BUILT LIKE HARDWARE. NOT A GADGET.
Every detail on CupDock does structural work — nothing is on there for looks.
Locks In, Doesn't Let Go
A flex-claw base grips the rim of your cup holder — not a strap, not a suction cup. It clamps to the structure that's already bolted to your car.
Rib-Reinforced For The Road
Every cutout in the spine is structural, not decorative — engineered to hold real weight through potholes, hard turns, and daily commuting.
Cable, Handled
An integrated channel runs your charge cable down the spine and out of sight — no more cords crossing your gear shift.
Eye-Level, Not Lap-Level
At 23.5cm, your screen sits at glance-height off the console — not buried in the well where you have to look away from the road to find it.
THREE SECONDS. ZERO TOOLS.
Position
Set the claw-lock base into your cup holder rim.
Lock
The flex-claws grip the rim on contact — no clips, no screws, no adhesive.
Dock
Slide your phone into the cradle and route the cable down the spine.
NOT A RENDER. A REAL CENTER CONSOLE.
Tap in and turn the sound on — this is what docking your phone actually sounds and looks like.
QUESTIONS, ANSWERED BEFORE YOU ASK.
The claw-lock base flexes to grip the standard cup holder diameters found in most sedans, SUVs, and trucks. It clamps to the rim itself, so it isn't relying on a single fixed size to hold on.
The cradle is sized for cased phones, with a camera cutout and button notch so your case doesn't get pinched and your ports stay clear for charging.
No — that's the entire point. CupDock stacks above the holder instead of sitting inside it, so the cup slot underneath stays fully open.
The rib-reinforced spine and claw-lock base are built to hold continuous force, not just friction — designed to stay put through turns, braking, and rough roads.
Clip the base into your cup holder rim and dock your phone — no tools, no drilling, no adhesive. Most drivers have it fully set up in under 10 seconds.
If the claw-lock doesn't grip your specific console the way it should, our support team will sort a fix or a return — no argument.
Drive for a rideshare app. This thing hasn't budged in three months. Cup holder still works too — I didn't think that was possible.
Install took less time than reading these reviews. Claw base gripped my console immediately, no wiggle at all.
Solid mount. Only wish the cradle was a hair wider for my case, but it still clicks in fine.
Finally my GPS isn't buried in the cup holder well. Can actually see it without looking away from the road.